It is not advisable to pull multiple cards out of a live, production chassis simultaneously. This procedure must be followed in its entirety for each card that is replaced, one card at a time. Note: This procedure can be used in order to replace multiple cards during a single maintenance window, as long as a single card is replaced at a given time. Perform a basic health check and ensure that there are no issues before you start the activity.

Use an anti-static protection strap/wristband.

Use a standard non-magnetic #2 screwdriver.Ensure console access using a serial Console cable for the console connection (supplied with chassis).Have appropriate hardware available for your chassis (highly recommended).Show support details to file /flash/ compress -no Take show support details (SSD) before and after the maintenance activity in case there is an issue to be investigated by the Cisco Technical Assistance Center (TAC) team.Save the current configuration and sync the file system.Prerequisites for Card Replacementsīefore you proceed with the steps outlined in this Method of Procedure (MOP), capture this important information in case you must undo your changes: Both cards are normally installed in a fully redundant chassis. The chassis can have a maximum of two MIO cards in Slots 5 and 6. Normally all cards are installed in a fully-populated chassis. Rear Cards Data Processing Card (DPC)Ĭhassis can have a maximum of eight DPC cards in Slots 1 to 4 and 7 to 10. Both cards are normally installed in a standard chassis. The chassis can have a maximum of two SSC cards in Slots 11 and 12. Presently Cisco uses four FSC cards in Slots 14 to 17. In order to see how your chassis is populated, enter this command: ASR5500# show card tableģ: DPC Universal Data Processing Card Active Noĥ: MMIO Management & 20x10Gb I/O Card Active NoĦ: MMIO Management & 20x10Gb I/O Card Standby -Ĩ: DPC Universal Data Processing Card Standby -ġ4: FSC Fabric & 2x200GB Storage Card Active Noġ5: FSC Fabric & 2x200GB Storage Card Active Noġ6: FSC Fabric & 2x200GB Storage Card Active Noġ7: FSC Fabric & 2x200GB Storage Card Active NoĢ0: NONE None - Front Cards Fabric Storage Card (FSC)Ĭhassis can have a maximum of four FSC cards. There are four types of cards that make up the ASR 5500 chassis. DO NOT remove more than one (1) card at a time from a chassis because this WILL result in traffic loss. Precautions must be taken when you replace or remove any cards from an ACTIVE chassis because this action might impact live traffic.Ĭaution: DO NOT perform card maintenance on more than one (1) card at a time on an ACTIVE powered-up production chassis. This document describes how to remove and replace different cards in the Cisco Aggregation Services Router (ASR) 5500 PRODUCTION chassis.

Mio Product Keygen